Not only do you not have running water, you’ll likewise run the risk of that pipe bursting.
Now that wintertime is in full swing, there will constantly be the danger that your water pipes will ice up even if you take precautions.
If this does take place, then you’ll wish to thaw out your pipelines.
Prior to you start the process, there are a few things to remember:
- Firstly, do not ever utilize an open flame in an attempt to thaw out your icy water pipes.
- Secondly, constantly examine the weather forecast.
- Sometimes the weather condition will certainly go back to normal after just a day, meanings the icy pipes might also thaw by themselves.
- If the temperature level looks like it is going to remain the exact same, you’ll need to set about the procedure of defrosting the pipes yourself.
What You Should Do To Thaw Your Pipes
As soon as you thaw your water pipes, a leak may take place. As a result of this, you must prepare to switch off the main shut-off shutoff.
If you do not know where it is located, be sure to discover it before you begin defrosting your frozen water pipes.
Examine both the cold and hot tap. Occasionally the cold water pipe may be frozen, yet the hot water pipeline will certainly still function.
If this holds true, then merely run your hot water for about 20 mins. The heat from the hot water pipes should transfer over to the frozen pipeline, assisting it to thaw out.
If both your hot water and cold water pipelines are frozen, you’ll wish to find the spot where the water pipe has iced up and use a hairdryer in order to heat it.
Use the highest heat setting on your hair clothes dryer and keep it a few inches far from the pipeline. If the place where the water pipe has actually iced up is out of view, use the hairdryer as close as possible.
The plumbing pipes tend to conduct heat fairly well, so the warmth of the hairdryer can transfer to the location that is frozen. This procedure takes just about 45 minutes.
If you are not sure of where the frozen pipeline is, or feel uncomfortable with trying to thaw it out yourself, you ought to call an local Toronto plumber.
Another tips to avoid frozen pipes
- Know where the water cut-off valve is located in your home. Make sure that every responsible person in the home is aware of its location.
- Remove, drain and carefully store hoses used outdoors.
- Keep garage doors shut if any water lines are located inside.
- Seal all openings where cold air can get at unprotected water pipes. As stated above, it’s especially important to keep cold wind away from pipes.
- Pipes in attics and crawl spaces should be protected with insulation or heat. Pipe insulation is available in fiberglass or foam sleeves. Remember, the more insulation you use, the better protected your pipes will be.
- During freezing weather, leave cabinet doors open under kitchen or bathroom sinks (especially if they are located against an outside wall) to allow warmer room air to circulate around pipes. You can also place a small lamp with an incandescent bulb near the pipes. Be sure to remove anything flammable from the area to prevent fires.
- Let faucets drip slowly to keep water flowing through pipes that are vulnerable to freezing. If the dripping stops, it may mean that ice is blocking the pipe. Keep the faucet open to assist in pressure relief.
- Heating cables and tapes are effective for freeze protection. Follow manufacturer’s directions closely when using these products.
- Exterior pipes and hose bibbs (outdoor faucets) should be drained or enclosed in 2-inch insulation sleeves.
- When weather is very cold, keep thermostats at the same temperature day and night. Lowered temperatures at night may contribute to colder attic temperatures and thus, more vulnerable pipes.
And these simple prevention measures and you’ll have one less reason to call a professional Toronto plumber. You have several options, some of which you can combine:
- Don’t turn your thermostat below 60°F.
- If pipes run under your attached garage, keep the door closed.
- Insulate exposed pipes with foam tubing. They’re slit on the side to make it easy to do this on your own.
- Another way to insulate pipes is with electric heating cables that neatly wrap around the pipes which you would then secure with tape.
- If you’re expecting frigid temperatures overnight and you KNOW you have un-insulated and exposed pipes, turn on one of your faucets just a little to keep the water flowing.
- If you undertake a remodeling job, hire a plumber to relocate any exposed pipes to a warmer location.
Ok If you are still looking for a plumber, Mister Plumber in Toronto, Etobicoke, Scarborough, North York specializing sewer repair, upgrade waterline, lead pipe replacement, water service upgrade, drain cleaning, backwater valve installation, lead pipe replacement, re-piping and emergency plumbing, Mister Plumber uses the latest technology to effectively troubleshoot and quickly repair any plumbing problem and offers a fast response and free estimates. Call us 416 939 1530 or fill the form for Online Free Estimate.